demandPlus+

⌘K
  1. Home
  2. Docs
  3. demandPlus+
  4. 1.2*
  5. Installation
  6. Assisted Setup

Assisted Setup

demandPlus+ uses HTTP requests for various functionalities. Without these functionalities you can only use demandPlus+ to a very limited extent. To allow HTTP requests for demandPlus+, please go to Extension Management. There, select the demandPlus+ extension and click on “Configure”.

Then please activate the field “Allow HttpClient Requests”.

In order to be able to use demandPlus+ fully, you should additionally run through the assisted setup of demandPlus+.
To do so, select “Set up demandPlus+” in the Assisted Setups.

The setup will then open and go through all important steps for the correct installation of demandPlus+.

First of all, a 30-day trial subscription is created for you. If you already have a subscription, this step will be skipped.

Here you can enter the necessary values for the planning calibration. Here you can find an explanation of the fields.

To use the demandPlus+ indicator, the bitmaps must be imported. To do this, please press “Next”.

After the import, you must fill the threshold values for the individual indicator.

The calculation type distinguishes between absolute and relative.
In planning calibration, the indicator refers to the maximum difference between the current value and the calculated value, or the new value and the calculated value. If the calculation type is set to relative, the absolute value (such as piece) is set in relation to the calculated value. In this case, the system uses a percentage as a threshold value.

After setting up, the data is stored in the demandPlus+ Setups.